Emission

The new generation of ISO Smart dust and gas sampler has been designed and developed in accordance with international standards for sampling stack emissions.
The sampler is equipped with five thermucuple inputs for flue gas temperature, heated sampling probe and filter holder temperature measurement and control. Measurement of the gas temperature that passes through the impingers also takes place with two additional temperature sensors and inputs.
Flue gas velocity measurement takes place with a pitot tube. The measured flue gas velocity is evaluated by the microprocessor and provides isokinetic sampling. Total gas volume of the sampler is measured by the dry gas meter. All measured temperatures are stored in the device memory. All of this process is automatic and controlled by the device's microprocessor.
The sampler has built-in water trap and sensor that detects the presence of liquids passing through the inlet. In the case of liquids pass througe the inlet by accident, this sensor automatically stop the pump and gives an alarm. The user can remove the water from the water trap from drain outlet. After removing the water the samplear start to operate automatically. This important feature of the device prevents damage to the internal parts of the device.

The ECO model of ISO Smart dust and gas sampler has been designed and developed in accordance with international standards for sampling stack emissions.
The sampler is equipped with three thermucuple inputs for flue gas temperature, heated sampling probe and filter holder temperature measurement and control.
Flue gas velocity measurement takes place with a pitot tube. The measured flue gas velocity is evaluated by the microprocessor and provides isokinetic sampling. Total gas volume of the sampler is measured by the dry gas meter. All measured parameters are stored in the device memory. All of this process is automatic and controlled by the device microprocessor.
The sampler composed by two units, the Control Unit and the Pump Unit. In this version, the user only moves the lightweight control unit to the sampling point. It does not need to move the heavy pump unit to the measuring point. It is possible for this sampler to keep this unit on the ground.

The sampler and dilution unit are in a single cabin. Flow control of both units is done with two independent mass flow meters integrated into the device. Total and dilution gas volume can measure with two independent dry gas meter. All of this process is automatic and controlled by the device's microprocessor.

The two streams are regulated independently, so for different stack condition the dilution ratio can be changed indepandantly. The temperatures inside both dry gas meters reads with two tempreture sensor and stores in the memory of the sampler.

The dilution and total sample inlets are equipped with two easily replaceable cartridges. In addition, the user can easily replace the cartridge silica gel and charcoal. Unlike traditional manual sampler, it is fully automated. Dilution and total flow rates can be adjusted digitally. The sampler automatically controls the set flow rates and adjusts the flow rates. The sampler also directly reads gas volumes and temperatures from the dry gas meter. Thus, it is not necessary to note the first and last readings and temperatures from the dry gas meter.